Activating The Setup Procedure - Datalogic Formula F7400 User Manual

Table of Contents

Advertisement

F7400 - USER MANUAL _________________________________________________________
5.2.

ACTIVATING THE SETUP PROCEDURE

The BSETUP.EXE program is the only way to modify the F7400 terminal parameters,
it is a normal DOS program and can be invoked after the F7400 terminal's boot
sequence.
BSETUP.EXE is intended to be invoked via the NEWAUTO.BAT, but you can use it
when you want at the DOS prompt, or you can remove it from the F7400 terminal.
Note that when BSETUP.EXE program runs, the F7400 terminal has just been done
the boot sequence, so the terminal is configured with one of the following:
- CMOS table
- EEPROM table
- DEFAULT table
The CMOS table parameters are considered the correct ones; the EEPROM table is
used only if the CMOS is corrupted and the DEFAULT table, that belongs to the
BIOS code, is used if no other choice is possible.
The application has the following three options:
BSETUP -C
the program checks the status of currently loaded parameters to see
if they are the CMOS. If so, the program exits, otherwise it asks if you
want to modify them. Default is no check;
BSETUP -N
if you select this option, the program does not convert the key to the
correct value, for example, if the program is waiting for a number, you
must put the keyboard in the correct state before pressing the
number. Default is conversion enabled;
BSETUP -D
with this option you can load the DEFAULT configuration
In the NEWAUTO.BAT file it is useful to invoke "BSETUP -C", even though the
BIOS, after the RAM test, displays information about the currently selected
parameters.
The application does not provide a method to change date/time, since you can use
the DOS commands DATE and TIME.
28
5
Ed.: 06/00

Advertisement

Table of Contents
loading

Table of Contents