Controlling Liebert Equipment - Liebert IntelliSlot Installation Manual

8.2

Controlling Liebert Equipment

To perform Control operations through the Web interface:
• Open the Web interface (if needed, see 3.5 - Open the Web Interface).
• Click on the Control tab, as shown in the following example.
Control tab
Control
Operations
Click to view in
right panel
• Control Operations categories appear at bottom left, organized with folder icons and showing
the available Control functions. Clicking on a category changes the view in the right panel. The
example above shows the summary page.
The following guide is a partial list of Control operations—these vary by the type of Liebert unit.
Table 24
Command
Abort Commands
Alarm Silence / Alarms
Output / System
Statistics
Tests
Setpoints
• To perform an operation, click on a Control Operations category at left, then click on the appropri-
ate button in the right panel. The example below shows control operations for two Liebert units.
Liebert
GXT2U
example
Output
Control operations parameters—functions vary by Liebert unit
Prevent any pending commands from being completed.
Temporarily silence an audible alarm that is active. Reset or acknowledge alarms
Turn the Liebert unit On or Off; reboot the unit.
Reset statistics—for example, battery or power statistics
Initiate diagnostic tests on the Liebert unit.
Change setpoints for the Liebert unit.
Liebert
DS
example
Setpoints
Monitor and Control Functions - Web Only
Description
46