Epson DM-D110 Technical Reference Manual page 23

9. Arrange the cables as shown below. Put the cables for the DM-D110 inside the DM-D stand.
10. Attach the base plate to the DM-D stand following the numbered arrows shown below. Then
push the base plate until it is locked by the hook on the DM-D stand.
11. When the extension support (DP-105) is used, attach Velcro tapes to the four corners of the
plate to keep the unit from falling down.
12. Connect the cord of the power unit to the socket. This completes the setting.
Note:
When connecting with the pass through connection or the standalone connection, step from 13
to 16 are not needed.
13. Connect the cable of the DM-D110 to the connector of the printer.
. A
Rev
1
2
DM-D110 Technical Reference Guide
Setup information 2-9