Cautions On Handling; Usage - Epson DM-D110 Technical Reference Manual

Chapter 2
Setup information

2.1 Cautions on Handling

When you use the DM-D110, be sure to note the following points:
Avoid locations that are subject to high temperature and humidity.
Avoid dirty and dusty locations.
Avoid locations that are unstable or are subject to high levels of vibration.
When connecting or disconnecting cables, make sure that the power switch of the DM-D110
and printers connected to the DM-D110 are turned off.
Do not drop the DM-D110 because you may damage the built-in vacuum fluorescent
display.

2.2 Usage

The DM-D110 can be used with the following equipment.
IR-320 series. You can attach the DM-D110 to the IM series using the "DM-D pole unit for
IR" (DP-504). (Refer to the IR-320 Technical Reference manual.)
IR-700 series. You can attach the DM-D110 to the IR-700 the DM-D support unit (DP-506) for IR-
700 series. (Refer to the IR-700 Technical Reference guide.)
SR-610 series. You can attach the DM-D110 to SR-610 series. You can attach the DM-D110 to
the SR-610 using the DM-D support unit (DP-504) for SR-610 series. (Refer to the SR-610 Technical
Reference guide.)
DM-D stand. You can attach the DM-D110 to the DM-D stand directly using the "DM-D
stand unit for DM Customer Display" (DP-110-1x1). When using the DM-D stand, an
optional power supply unit (PS-180) is required. Also, if you want to extend the height of the
DM-D110, an optional extension support unit (DP-105) is required. (See page 2-2.)
TM-H6000 series/TM-U675. You can attach the DM-D110 to TM-H6000II/TM-U675 printers
using the "DM-D pole unit for TM printers (Type A)" (DP-502). (See page 2-11.)
TM-H5000 series/TM-J8000 printers. You can attach the DM-D110 to TM-H5000II/TM-
J8000 printers using the "DM-D pole unit for TM printers (Type B)" (DP-503). (See page 2-
16.)
TM-U950. You can attach the DM-D110 to the TM-U950 printers using the "DM-D pole unit
for TM printers (Type A)" (DP-502). (See page 2-18.)
Other TM printers. You can attach the DM-D110 using the "DM-D pole unit for TM printers
(Type A)" (DP-502) and Velcro tapes or screws. (See page 2-21.)
. A
Rev
DM-D110 Technical Reference Guide
Setup information 2-1