Increasing Cooking Levels; Decreasing Cooking Levels; Switching Off A Cooking Zone; Boost Functionality (Automatic Heating Up / Ankochstoss) - Electrolux HIC Service Manual

4.2

Increasing cooking levels

- With the zone '+'buttons the cooking levels can be stepped through from level 0 to the
maximum cooking level.
- The power for the zone has to be switched on at the start of increasing the level.
4.3

Decreasing cooking levels

- With the zone '-' buttons the cooking levels can be stepped through in the following way:
- e.g.: 0 – 9 – 8 – 7 – 6 – 5 – 4 – 3 – 2 – 1 – 0
- The power for the zone has to be switched off at the start of decreasing the level.
4.4

Switching off a cooking zone

A cooking zone can be switched off by
- Decreasing the cooking levels down to zero.
- Pressing the '+' button and the '–' button of one zone together.
- Pressing the "OFF" button of the hob, then the whole hob is switched off.
4.5

Boost functionality (Automatic heating up / Ankochstoss)

To reach the temperature for a cooking zone as fast as possible the hob has a boost function. In
boost mode ("A") the hob is working with cooking level "9".
If the boost function is active, the letter „A" (german: Ankochstoß) is displayed in the 7-Segment
display of the zone.
Setting of boost function is only possible, if cooking zone is in state cold, which means there is no
„H" in the zone display.
If the boost mode is activated the displays changes after approx. 3 sec from the cooking level to
"A".
If the zone is in boost mode and the '+'button is pressed, the actual cooking level has to be shown
in the display again.
If the zone is in boost mode and the '–' button is pressed, the actual cooking level has to be shown
in the display again.
The boost function must be switched off by the following events:
- Boost time has elapsed. This information comes from the power board with a „hob control
status message".
- Cooking level has been decreased.
- Cooking level has been set >"9" or "P").
- Keep warm function has been activated.
- Power function, "normal setting" has priority, see chapter Power Management

4.5.1 Automatic boost

Setting of cooking level with boost function
Starting from "0" by increasing the cooking level with the '+' button the boost function will be
activated automatically.
Setting of cooking level without boost function:
This can be done by pressing the "–"-button of a cooking zone. In this case you step in the opposite
way through the cooking levels, e.g.
0 – 9 – 8 – 7 – 6 – 5 – 4 – 3 – 2 – 1 – u – 0
DGN-TDS-N 11.03 U. H. / A. B. © Electrolux - 13 - 599 512 232 EN