The Recover Button - Dish Network Dish ViP722K User Manual

T R B
HE ECOVER
Use RECOVER if you have a snowy, all blue, or black screen on your TV and cannot get
the picture back from your satellite receiver. When you press RECOVER as described, the
remote control sends commands to your TV to change channels or video inputs to get
back to watching satellite programming. This procedure works only if you have
accidentally changed the TV channel or video input. It does not recover lost satellite signal
(See Troubleshooting on page 134 for more information).
Note: The remote must be programmed to control the TV (and VCR, if applicable) in order
for RECOVER to work as described.
Note: The RECOVER feature will first try to tune your TV to channel 3, then to channel 4,
and then change to other video inputs with each press of the RECOVER button. You may
need to press the RECOVER button up to 30 times to recover your satellite TV video. If
RECOVER has been programmed to use a specific channel, RECOVER will tune the TV
to this specific channel first (for example, to channel 60).
Programming the Recover Button for Remote Control 2
When your Remote Control 2 is shipped from the factory, the RECOVER button is set up
to restore satellite TV viewing by tuning your TV (or VCR) to channel 3 or 4, and other
input(s). The following instructions describe how to program the RECOVER button to tune
your remote TV (or VCR) back to a selected TV channel.
1
Turn on your TV and program Remote 2 to control your remote TV (see and page 82
and 83.
2
Press and hold the TV mode button until all the Mode buttons light up.
3
Press STAR (*).
4
Enter the specific three-digit number channel that you use to watch TV2 programming.
(For two-digit number channels, use a zero first. For example, enter channel 60 as 060.)
5
Press and hold POUND (#). The TV mode button will flash three times.
UTTON
Remote Controls

The Recover Button

93