GE Homespring Operation Manual page 14

3
Setting the Program
Choosing a program:
Water Clarity
Low Turbidity
less than 0.5 NTU
Medium Turbidity
Peaks to 1.0 NTU, less than 72
min. per day
High Turbidity
Peaks to 5.0 NTU, less than 72
min. per day
Very High Turbidity
Peaks to 10.0 NTU, less than 72
min. per day
NOTE: If surface water is the source, select either Program 3
or Program 4 in this application.
Advanced
Cleaning
Plus
Sequence
Controller
Program 1 2 flushes
Program 2 4 flushes
2 flushes & 1
Program 3
drain
2 flushes & 2
Program 4
drains
1) Press NEXT four times until "PROGRAM" flashes on
screen. Press eNTeR.
3) Press the UP and DOWN arrows to set the Program
number. Select the appropriate Program for your
application. Press ENTER.
14
Advanced Plus Controller
Program 1
Program 2
Program 3
Program 4
Approx Water
Consumption Per
Duration
Cleaning Cycle at 5
gpm
2.5 min 7.5 gal
6 min 15 gal
8.5 min 13.5 gal
16.5 min 19.5 gal
figure 17
4
Setting the Flush/Drain Interval:
figure 18
1) Press NEXT five times until "t:01" appears on screen.
2) To change the flush/drain interval setting, press and
hold the UP and DOWN arrows together and press
NEXT. Release all buttons and repeat to shift to the next
interval. There are five interval settings to choose from:
No. of
Flush/Drain
Flush/Drain Cycles
Interval Setting
per Day
t:01 1 time
t:02 2 times
t:04 4 times
t:08 8 times
t:24 24 times
NOTE: Under conditions of turbid water and high usage of
the system, select a flush/drain interval setting appropriate
to the specific application. Increase frequency of flush/drain
cycle if the system TMP rises too quickly. Increasing the
number of flush/drain cycles per day will prolong the life of the
system; however, more water will be used for system cleaning
purposes.
Time Interval Between
Flush/Drain Cycles
24 hrs
12 hrs
6 hrs
3 hrs
1 hr