Remove Battery; Insert Battery In Hazloc Mx9; Remove Battery From Hazloc Mx9 - Honeywell MX9 User Manual

Microsoft windows ce 5 operating system

Hide thumbs Also See for MX9:

Table of Contents

Remove Battery

To remove the battery, complete the following steps:

1. Place the MX9 in Suspend mode.

2. Detach the bottom hook of the handstrap (if installed).

3. Slide the battery retaining clip down to release the main battery.

4. Pull the battery up and out of the battery well with a hinge motion.

Place the discharged battery pack in a powered battery charger.

1. Detach the bottom hook of the handstrap (if installed).

2. Tilt the end (with the terminals) of the fully charged battery pack into the upper end of the battery compartment, and

firmly press the other end until it is seated into the battery compartment.

3. Push down on the battery pack until it clicks into place.

4. Place the tethered plastic locking tab over the battery latch, matching up the screw holes in the MX9 and the screw

holes in the tethered plastic locking tab.

5. Using a flat head screwdriver, secure the battery in the battery well by securing the locking screws to the MX9 body.

6. Replace the hand strap clip in its holder.

1. Place the MX9 in Suspend mode.

2. Detach the bottom hook of the handstrap (if installed).

3. Using a flat head screwdriver, unfasten the tethered plastic lock's captive locking screws.

4. Place the tethered plastic locking tab to one side. Do not remove or unfasten the tether.

5. Press the battery locking tab down to release the battery pack.

6. Pull the battery up and out of the battery well with a hinge motion.

Place the discharged battery pack in a powered battery charger.

2-3

Table of Contents