Pro-Form PETL11711.0 User Manual page 8

2. Attach a Wheel (96) to the Base (95) with a 3/8"
x 2" Bolt (8) and a 3/8" Nut (10). Do not over-
tighten the Nut; the Wheel must turn freely.
Press a Base Cap (89) into the Base (95).
3. Identify the Right Upright (85), which is marked
"Right." Hold the Right Upright near the Base
(95) as shown.
See the inset drawing. Tie the wire tie in the
Right Upright (85) securely around the end of
the Upright Wire (87). Then, pull the other end
of the wire tie until the Upright Wire is routed
through the Right Upright.
2
Plastic Tie
87
8
95
96
10
3
87
Wire Tie
85
Wire
Tie
87
8
89
85
87
95