The Dot Moves Automatically Or Does Not Move To The Next Position During Calibrating Manually; Other Problems; No Sound Can Be Heard Or The Sound Is Faint - Epson EB-585W User Manual

Problem Solving

The Dot Moves Automatically or Does Not Move to the Next Position during Calibrating Manually

Check
Information from the projection screen is not correctly received due
to other things, such as a light source that is emitting infrared rays.
Information from the projection screen may not be received
correctly if the projector is too close to the screen.
The interactive pen is disabled due to unstable conditions in the
surrounding area, such as a light source that is emitting infrared
rays.

Other Problems

No Sound Can Be Heard or the Sound Is Faint

Check
Check that the audio/video cable is securely attached to both the
projector and audio source.
Is the projector volume set to the minimum?
Is the volume for the computer or from the image source set to the
minimum?
Is the Mic Input Level set at the maximum?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
Is it connected with an HDMI cable?
Is Output audio from the projector selected?
(Only when projecting USB Display)
Move the device, such as a light source that is emitting infrared rays, away from the projector, or move the projector away
from the device.
Setup within the recommended projection distance.
s "Screen Size and Projection Distance"
Move the projector or turn off the interfering device, such as a light source that is emitting infrared rays.
Disconnect the cable from the audio input port, and then reconnect the cable.
Adjust the volume so that sound can be heard.
s Settings - Volume p.122
s "Adjusting the Volume" p.57
Adjust the volume so that sound can be heard.
Lower the Mic Input Level.
s Settings - Mic Input Level p.122
Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)"
When using a commercially available audio cable, make sure it is labeled "No resistance".
If no audio is output when connecting via an HDMI cable, set the connected equipment to PCM output.
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Ver.x.xx Settings, and then select
the Output audio from the projector checkbox.
Remedy
p.175
Remedy
p.93
155