The Mouse Cursor Flickers (Only When Projecting Usb Display); The Image Is Truncated (Large) Or Small, Or The Aspect Is Not Suitable - Epson EB-585W User Manual

Problem Solving

The Mouse Cursor Flickers (only when Projecting USB Display)

Check
Is Make the movement of the mouse pointer smooth. selected?

The Image Is Truncated (Large) or Small, or the Aspect Is Not Suitable

Check
Is a wide-panel computer image being projected?
(Only when projecting computer images)
Is the image still being enlarged by E-Zoom?
Is the display position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Is the correct resolution selected?
(Only when projecting computer images)
Did you adjust the image position after performing Adjust Zoom or
Keystone?
Is the projection mode correct?
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Ver.x.xx Settings, and then select
the Make the movement of the mouse pointer smooth. checkbox. (Windows 2000 is unavailable.)
Windows Aero becomes unavailable if this is selected in Windows 7 and Windows Vista.
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.120
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
(Only when projecting analog RGB signals input from the Computer1 or Computer2 port)
Press the [Auto] button on the remote control or the [Enter] button on the control panel to adjust the position.
You can also adjust the position from the Configuration menu.
s Signal - Position p.120
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.178
s Computer's documentation
Perform Image Shift to adjust the image position after performing Adjust Zoom or Keystone.
s "Adjusting the Position of the Image (Image Shift)"
Depending on how the projector is installed, set Projection from one of the following: Front, Front/Upside Down,
Rear, Rear/Upside Down.
s Extended - Projection p.123
s "Installation Methods" p.25
Remedy
Remedy
p.94
p.53
150