No Sound Can Be Heard From The Microphone; There Is Noise In The Audio (Only When Projecting Usb Display); The Remote Control Does Not Work - Epson EB-585W User Manual

Problem Solving
Check
Is the correct audio input selected?

No Sound Can Be Heard from the Microphone

Check
Is the microphone connected correctly?
Is the microphone input volume turned down too low?
Are you using a plug-in power type microphone?

There Is Noise in the Audio (only when Projecting USB Display)

Check
Is the volume for the computer set to minimum while the projector's
volume is set to maximum?

The Remote Control Does Not Work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Check the Audio Output, HDMI1 Audio Output, and HDMI2 Audio Output settings from the Configuration menu.
s Extended - A/V Settings p.123
Disconnect the cable from the Microphone (Mic) port, and then reconnect the cable.
s "Connecting a Microphone" p.36
Adjust the microphone input volume so that sound can be heard.
s Settings - Mic Input Level p.122
The projector does not support plug-in power type microphones. Use a commercially available dynamic microphone.
s Settings - Mic Input Level p.122
The audio may contain noise if the volume for the computer is set to minimum while the projector's volume is set to
maximum. Increase the volume for the computer, and decrease the volume for the projector.
s Settings - Volume p.122
Point the remote control towards the remote receiver during operation.
s "Remote Control Operating Range"
The operating range for the remote control is about 6 m.
s "Remote Control Operating Range"
Set the projector up in a location where strong light does not shine onto the remote receiver.
s Settings - Remote Receiver p.122
Remedy
Remedy
Remedy
Remedy
p.20
p.20
156