Installing The Shelf Supports; Oven Lamp; Cleaning The Oven Door - Electrolux EOA5551AOX User Manual

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
10.3 Catalytic walls
The walls with catalytic enamel are self-
cleaning. They absorb fat which collects
on walls when the oven operates.
To support the self-cleaning process:
1. Activate the oven lamp.
2. Remove the accessories from the ap-
pliance.
3. Clean the oven floor with warm water
and washing-up liquid, then dry it.
4. Set the function
temperature.
5. Let the empty appliance operate for
one hour.
6. When the appliance is cool, clean it
with a soft and moist sponge.
WARNING!
Do not clean the catalytic surface
with oven sprays, abrasive clean-
ing agents, soap or other cleaning
agents. There is a risk of damage
to the catalytic surface.
WARNING!
Keep children away when you
clean the oven at a high tempera-
ture. The oven surface becomes
very hot and there is a risk of
burns.
Discolouration of the catalytic sur-
face has no effect on the catalytic
properties.
and maximum

10.4 Oven lamp

WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
1.
Turn the glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4. Install the glass cover.

10.5 Cleaning the oven door

The oven door has three panels of glass.
You can remove the oven door and the
internal glass panels to clean them.
The oven door can close if you try
to remove the glass panels before
you remove the oven door.
ENGLISH 21