Shelf Supports; Removing The Shelf Supports; Installing The Shelf Supports; Steam Generation System - Electrolux EBSL7 User Manual

11.2 Shelf supports

You can remove the shelf supports to
clean the side walls.

Removing the shelf supports

1
2
1. Carefully pull the supports up and out
of the front catch.
2. Lightly move the supports on the front
catch inwards.
3.
Pull the supports out of the rear
catch.

Installing the shelf supports

Install the shelf supports in the opposite
sequence.

11.3 Steam generation system

CAUTION!
Dry the steam generator after
each use. Soak up water with the
sponge.
A
3
A
Remove the limescale residue
with water and vinegar.
CAUTION!
Chemical de-scaling agents can
cause damage to the enamel. Fol-
low the instructions of the manu-
facturer.
Cleaning the water drawer and the
steam generator:
1.
Put the water and vinegar mixture
(approximately 250 ml) through the
water drawer into the steam genera-
tor.
Wait for approximately 10 minutes.
2. Remove the water and vinegar with
the sponge.
3. Put clean water (100 - 200 ml) into
the water drawer to flush the steam
generation system.
4. Remove water from the steam gener-
ator with the sponge and rub dry.
5.
Keep the door open to let the appli-
ance dry fully.
11.4 Removing / inserting the
door
To clean the door remove it.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Removing the door
1.
Open the door as far as it goes.
2. Press down the clamping levers (A)
on the two door hinges.
ENGLISH 19