Programmable Key Functions - Icom Iç-V88 Operating Manual

2

PROGRAMMABLE KEY FUNCTIONS

Programmable key functions (Continued)
DTMF AUTODIAL
Push to enter the DTMF number selection mode,
➥
then select a DTMF number by pushing [CH Up] or
[CH Down].
After selecting the DTMF number, push again to
➥
transmit the selected DTMF code.
RE-DIAL
Push to transmit the last-transmitted DTMF code.
➥
NOTE: TX memories are cleared after turning OFF
the transceiver.
SURVEILLANCE
Push to turn the Surveillance function ON or OFF.
➥
• When this function is ON and a signal is received, a beep
does not sound and the LED does not light, even if you
push any key.
SIREN
Hold down to sound a siren.
➥
• You may use this function for other than an emergency
alert. For example, use it as a security alarm.
Turn OFF the transceiver power to stop the siren.
➥
SCRAMBLER
Push to turn the Voice Scrambler function ON or
➥
OFF.
COMPANDER
Push to turn the Compander function ON or OFF.
➥
• The Compander function reduces noise components
from the transmitted audio to provide clear communica-
tion.
USER SET MODE
Hold down to enter the User Set mode.
➥
• While in the User Set mode, push this key to select an
item, and then change the value or setting by pushing
[CH Up] or [CH Down].
Briefly hold down this key again to exit the User Set
➥
mode.
ANNOUNCE
Push to turn the Channel Announce function ON or
➥
OFF.
NOTE: When the Beep function (p. 6) is OFF, the
operating channel is not announced, regardless of
this setting.
SHIFT
1. Push to turn ON the Shift mode key functions.
• "SHIFT ON" is briefly displayed.
2. Push another key to activate its secondary function.
3. Push [Shift] again to turn OFF the function.
• "SHIFT OFF" is briefly displayed, and then the transceiver
returns to the Normal mode.
• The Shift mode enables a programmable function key to
have two functions.
4