Front Panel Programming; Front Panel Programming Mode; D Entering The Front Panel Programming Mode; D Selecting A Channel To Program - Icom Iç-V88 Operating Manual

5
Section

Front Panel Programming mode

The following settings can be changed in the Front
Panel Programming mode without a PC. This is a con-
venient function to immediately change some settings
when you operate the transceiver in the field.
• Receive (RX) and Transmit (TX) frequencies
• RX and TX CTCSS tone frequencies
• RX and TX DTCS codes
• Channel name
NOTE:
While the transceiver is in the Front Panel Program-
ming mode, you cannot receive or transmit.
D Entering the Front Panel Programming
mode
[VOL] to turn OFF the transceiver.
Rotate
q
While holding down
w
transceiver.
• "SET MODE" is displayed.
Push [P0] to enter the Front Panel Programming
e
mode.
• A zone number and a channel number are displayed.
zone channel
To exit the Front Panel Programming mode and return to
the normal operation:
Turn OFF the transceiver.
➥

FRONT PANEL PROGRAMMING

[P0] and [UP], turn ON the
D Selecting a channel to program
After a zone and a channel number are displayed, as
q
described to the left, push [P3] to enter the Channel
Selection mode.
• The channel number blinks.
[P1] several times to select a zone.
Push
w
Push [UP] or [DOWN] to select a channel you want
e
to program.
[P3] again to set the channel.
Push
r
• The channel number stops blinking.
7