D Other Settings; Front Panel Programming - Icom Iç-V88 Operating Manual

5

FRONT PANEL PROGRAMMING

Front Panel Programming mode (Continued)
D Other settings
To deactivate the channel:
Select a desired zone and a channel, as described
q
on page 7.
[P2] to deactivate the selected channel.
Push
w
• "" is displayed.
• The channel cannot be used until you reactivate it.
[P2] to activate the channel.
Push
➥
• "" disappears.
To toggle between Wide and Narrow channel pass-
band width:
Select an RX frequency as described on page 8.
q
Push [P1] to toggle the channel passband width.
w
• "WIDE" or "NARROW" is briefly displayed.
• You cannot toggle the channel passband width while the
cursor is blinking.
[P1]
LED: Green
[P1]
11
To clear the RX frequency memory:
Select an RX frequency as described on page 8.
q
[P2] to clear the memory.
Push
w
• "CH OFF" is displayed and the channel will be cleared.
• You cannot clear the RX frequency memory while the cur-
sor is blinking.
To use the channel again, push
➥
frequency again.
To Inhibit or allow transmission:
Select a TX frequency as described on page 8.
q
[P2] to inhibit transmission.
Push
w
• "TX INH" is displayed.
• You cannot inhibit transmission while the cursor is blink-
ing.
[P2] to allow transmission.
Push
➥
LED: Green
[P2] and set the RX
LED: Red