Icom Iç-V88 Operating Manual page 11

5
FRONT PANEL PROGRAMMING
Front Panel Programming mode
D Selecting the RX and TX tones (Continued)
[P2] to select the CTCSS tone frequency, or
Push
w
DTCS code screen, or to turn OFF the CTCSS tone
frequency.
[P2]
[P2]
[P3] to enter the CTCSS Tone Frequency or
Push
e
DTCS Code Selection mode.
• CTCSS Tone Frequency Selection mode
[P3]
The frequency blinks.
• DTCS Code Selection mode
[P3]
The cursor blinks at
the fist digit.
[P2]
Setting the CTCSS tone frequency:
When CTCSS tone is selected, push
r
to select the frequency.
[P3] again to set the frequency.
Push
t
• The frequency stops blinking.
Setting the DTCS code:
When DTCS code is selected, push
r
to select the code digit.
[P3] to move the cursor to the next digit.
Push
t
Repeat steps r and t, until you finish selecting the
y
code.
Push [P1] to toggle the DTCS code's polarity while
u
the cursor is blinking.
• You can select Normal or Inverse polarity.
Normal
Inverse
[P1]
[P3] again to save the code.
Push
i
• The cursor stops blinking.
9
[UP] or [DOWN]
[UP] or [DOWN]
[P1]