Adjusting The Ez-Tracktm Refrigerator Shelf - Whirlpool 22’ TO 25’ NO-FROST DESIGNERSTYLE TOP FREEZER REFRIGERATOR WITH THIRSTCRUSHERDISPENSING SYSTEM Use & Care Manual

Adjusting the EZ-TRACKTM SPILLGUARDTM
refrigerator shelf
The EZ-TRACK shelf slides from side to side for more
flexible storage in your refrigerator.
To slide shelf side to side:
1.
Lift slightly on shelf front.
2. Slide to desired location.
3. Lower shelf front to level position.
NOTE:
You do not have to remove small items from
the shelf before moving it side to side. You may need
to remove larger items.
To remove the shelf:
1.
Remove all items from the shelf.
2. Hold back of shelf with one hand.
3. Lift front of shelf to 45" angle.
4. Lower shelf slightly to release shelf from upper
channel of track. Then pull shelf straight out.
NOTE:
Shelf is heavy. Make sure you use both hands
when removing shelf.
To remove shelf track:
1.
Lift both sides of track slightly.
2. Pull track straight out.
To replace shelf track:
1.
Guide track hooks into the shelf support slots on
the back wall of the cabinet.
NOTE:
Make sure both track hooks are in slots and
that the slots are parallel to each other.
2. Push track backward and down.
3. Check that track is completely seated in the
shelf supports.
then slide to new locatlon.
Upp:r channel
Hold with both hands
and lift front to 45" angle.
Make
sure
both
sets of
hooks
are in
support
slots.
Hold both sldes and
lift up and out.
' '
Shelf
L support
10