T2Dab Quick Setup Guide For Use With Nuvonet - Nuvo NV-T2DAB Installation Manual

Dual am/fm tuner

Hide thumbs

Table Of Contents

Table of Contents

T2DAB Wiring Diagram

FM antenna represented is not

included.

DAB antenna represented is not

included.

VARIABLE

OUTPUT

OUTPUT POWER

TIP=L

20W/6OHM X2

RING=R

FIXED

OUTPUT

ZONE 1

ZONE 2

SOURCE INPUTS

The T2DAB Dual Tuner is the perfect broadcast music solution for whole-home audio. The internal NuVoNet capability of the T2DAB

allows it to easily communicate in real time with the NuVo Grand Concerto and Essentia E6G Control Pads. The following is a step-

by-step guide for setting up and installing the T2DAB for use with the Grand Concerto and Essentia NuVoNet Suites.

Step 1: Upon unpacking your T2DAB Tuner, establish what audio inputs, 1-6, the T2's A and B audio outputs will represent. Plug the

T2 into an AC power source.

Step 2: Attach the audio outputs A and B of the Tuner to the appropriate numbered inputs on the Grand Concerto or Essentia

System.

Step 3: Connect the CAT5 from the NuVoNet output on the rear panel of the Tuner to one of the Device inputs on the Grand Concerto

EZ Port or the Essentia Allport. This will enable communication to the System's Control Pads. Note that a single CAT5 connection

provides information from both tuners A and B. A final CAT5 Connection should then be made to the NuVoNet CAT5 input on the

back panel of the Grand Concerto or Essenita main amplifier for the NuVoNet RJ45 on the Grand Concerto EZ Port or the Essentia

Allport. This completes the necessary connection for the NuVoNet communication.

AUDIO

IR INPUT

TUNER A

TUNER B

VARIABLE

OUTPUT

OUTPUT POWER

TIP=L

20W/6OHM X2

TIP=L

20W/6OHM X2

RING=R

FIXED

OUTPUT

ZONE 3

ZONE 4

CONNECT TO

NV-I8X

USE NV-SLC1

CABLE

SOURCE LINK

SOURCE STATUS INPUTS