Installing The T2Dab In The Home; Connecting The Audio Outputs; Setting The Audio Outputs For Nuvonet Or Standalone Use - Nuvo NV-T2DAB Installation Manual

I. Installing the T2DAB in the Home
Connecting the Audio Outputs (Fig. 1)
The T2DAB has two independent audio outputs labeled A and B.
These are standard stereo RCA connections and can be
connected to any device designed to receive an analog stereo
audio signal.

Setting the Audio Outputs for NuVoNet or Standalone use

(Fig. 2)
The outputs A and B are individually set from the front panel
display of the T2DAB. When the tuner is initially plugged into
an AC power source, a short setup wizard will appear on the
display. A message, "Uninitialized State Detected (Press OK)"
will appear. When OK is pressed, the prompt is to select a
regional tuning standard. The choices are USA/Canada,
Western Europe, Australia, and New Zealand. Use the Up and
Down arrows to highlight the appropriate choice and touch the
OK button to select. Once regional tuning has been selected,
the display will prompt for the use of each output A and B.
"+Output A" will highlight automatically. Using the up and
down arrows on the front panel, move the highlight to the
appropriate use of the tuner output and touch OK. The choices
are Stand Alone, Source 1, Source 2, Source 3, Source 4, Source
5, and Source 6. For any use other than with the Essentia E6G
or Grand Concerto Systems, select Stand-alone. This will
require IR or serial control of the T2DAB's functions.
Highlighting the appropriate Source number input for the NuVo
system and touching the OK button sets NuVoNet
communication. Once Output A is set, the highlight will move
to Output B. For operation, both outputs A and B must be set as
Stand Alone or as a NuVoNet Source.
When the Tuner's outputs are set, they will return to FM 87.9,
or the minimum FM band setting for the selected regional
tuning parameters. At this point the T2DAB is ready for either
NuVoNet communication or standalone use, depending on the
setting made for both outputs.
DAB Channel Scan (Fig. 3)
The DAB tuner will run a full channel scan of the entire DAB
frequency range after the initial setup simultaneously for both
tuners A and B. The ensemble count and available stations will
increment as the scan completes itself. After the scan is
complete, the number of (on-air) channels found is displayed.
Fig. 1
ZONE 1
1
L
R
1
Fig. 2
Uninitialized
State Detected
(Press OK)
Regional Setup
US and Canada
Western Europe
Australia
Set TunerA Mode
Standalone
Source 1
Source 2
7
USE NV-T2FAA
ANTENNA
AUDIO AUDIO
IN
L R L R
ANTENNA TUNER A TUNER B
VARIABLE VARIABLE VARIABLE
OUTPUT OUTPUT SPEAKER OUTPUT SPEAKER
SPEAKER
40W/6 OHMS X 2
40W/6 OHMS X 2 40W/6 OHMS X 2
TIP=L TIP=L TIP=L
LEFT RIGHT LEFT RIGHT
LEFT RIGHT
RING=R RING=R RING=R
FIXED FIXED FIXED
OUTPUT OUTPUT
OUTPUT
ZONE 2 ZONE 3
2 3 4 5 6 1 2
CONNECT TO
NV-I8X
L L
USE NV-SLC1
CABLE
R R
4 5
2 3 4 5 6
SOURCE INPUTS SOURCE LINK SOURCE STATUS
MENU A/B DISP
BAND
OK
MENU
A/B DISP
BAND OK
MENU A/B DISP
BAND OK
VARIABLE
SPEAKER
OUTPUT
40W/6 OHMS X 2
TIP=L
LEFT RIGHT
RING=R
FIXED
OUTPUT
ZONE 4
3
6