5.0 Update System - Nuvo NV-T2DAB Installation Manual

Fig. 37
4.3 Fine Tuning: When selected, Fine Tuning changes the
tuning standard for FM from the default .10 MHz tuning to .05
MHz step tuning, and AM will tune by single kHz increments,
rather than the default 10 kHz for USA and Canada, and 9 kHz
for Europe. Smaller tuning steps allow access to all station
frequencies.

5.0 Update System

5.1 Help About (Fig. 40): When you are ready to download
your configuration to the T2DAB, connect your computer to the
DB9, RS232 port on the back panel of the Tuner. Note that you
may need a USB to RS232 cable if your computer is not
equipped with a serial port. You can click on "Help" and then
"About" to confirm communication between the computer and
the Tuner. The initial software screen will appear. If the current
Tuner firmware information is listed in the bottom right-hand
corner of the screen, you have good communication. If it does
not appear, check your cable connections, and make sure the
Tuner is powered on. Often, lack of communication is fixed by
closing and reopening the Configurator.
Fig. 38
5.2 Download Configuration (Fig. 39): The final step in the
setup is to download the configuration to the T2DAB via its
RS232 serial port. A progress bar will indicate the actual
download process.
Fig. 39
20
19