Back Panel - Nuvo NV-T2DAB Installation Manual

AUDIO
L
TUNER A
1 2
Back Panel Features
1. Antenna Input: These "F" connectors are the coaxial cable connections for FM and DAB signal reception.
2. Audio Output: The audio broadcast for AM and FM received by the Tuner module is available through this stereo RCA output.
Tuner A and B offer independent audio outputs for use with the NuVo audio systems or third
party receivers and amplifiers.
3. IR Input: The T2DAB offers a single stereo mini, 3.5mm, connection for independent IR control of both tuners A and B.
4. NuVoNet: This single CAT5 connection provides full NuVoNet communication for both tuners A and B to the NuVo Grand Concerto
and Essentia E6G audio distribution systems. This connection is made at the Grand Concerto EZ Port or the Essentia
E6G Allport.
5. RS232: This DB9 9-pin connector is used for configuration programming (see section IV. Using the Tuner Configurator Software,
pg. 15) and bidirectional serial control from a third party home automation controller.
6. AC Power: The T2DAB is designed to plug into any AC power source. The digital switching power supply allows the tuner to
respond to any world wide voltage.
AUDIO
IR INPUT
R L R
TUNER B
3
Model NV-T2DAB
Dual SIRIUS Ready AM/FM Tuner
NuVo Technologies LLC Hebron, KY USA •
NuVoNet RS 232
www.nuvotechnologies.com
SYSTEM
5
4
5
0728
RoHS
CM
CONFORMS TO UL
STD.60065 CERTIFIED
TO CAN/CSA STD.
3033118
C22.2 No.60065:06
6