Advanced Settings; Advanced Config - Nuvo NV-T2DAB Installation Manual

3.4 Erase Bank (Fig. 34): All preset banks, with the exception
of the first bank, can be erased one bank at a time. You cannot
erase the first bank of 20 presets.
Fig. 34

Advanced Settings

The Tuner software contains several specialized settings for
more advanced setup. Clicking on view and selecting
"Advanced" will expand the tabs as discussed in the next
section to allow access to this functionality.
4.0 Advanced Config (Fig. 35)
The Tuner software allows for more advanced settings that, if
necessary, allow you to tweak the tuner's operation. The
process for beginning a new configuration or editing an
existing one does not change from the standard mode.
Fig. 35
4.1 Custom Regional Setup (Fig. 36): Some countries operate
at a tuning standard outside the four preset regions. The
Custom setting allows specific parameters to be set. One
determining factor for tuning is the "Pre-emphasis". The two
choices for this are 50µS (microseconds) and 75µS. The
custom setting also allows for specific setting of the minimum
and maximum tuning capability and the individual tuning
steps for FM and AM. Note that the AM band is not available for
the T2DAB model.
Fig. 36
4.2 Tuning Parameters (Fig. 37): This section determines how
the NV-T2DAB tunes up and down within the FM frequency
range. Seek/Scan Levels for FM set the signal strength
parameter for searching stations. Level 0 (Low), causes the
tuner to stop at any frequency with a very low signal, and
Level 4 (High), stops only when a very strong signal is
detected. The factory default is Level 2 (Medium), which
searches for a moderate signal. This setting changes the
necessary signal threshold, which is the minimum signal level
required for the Tuner to recognize it and lock on to the
frequency.
19