Nv-T2Rc4 Remote Control - Nuvo NV-T2DAB Installation Manual

NV-T2RC4 Remote Control

1. Power: The power button turns the Tuner on and off.
2. Tune Buttons: These buttons are the equivalent of using the Up and Down arrows on the front panel of the T2DAB to tune.
3. Band: This button toggles through the Tuner's available broadcast bands.
4. Seek Up and Down: The seek buttons will tune to the next available station with the required signal strength for FM use.
The signal threshold can be adjusted higher or lower using the Tuner Configurator software (see Section IV. Using the
Tuner Configurator Software, pg. 18), or through the advanced menu options on the front panel (see Section II. T2FAM-EX
Front Panel Menu, Seek Thesholds, pg. 11).
5. Preset Tune: These buttons step through the assigned presets. The T2DAB is capable of 5 banks of 20 presets.
6. Category Tune: Category Tune is not implemented on this model.
7. Pre: This button is used to establish a preset bank and preset number for the frequency being displayed on the selected
Tuner. To tune to a specific preset, push "Pre" followed by the bank number (1-5) then the 2-digit preset number
(01-20).
8. Tuner A & B LED: This LED glows red when Tuner A is selected and green when Tuner B is selected. This LED glows only
momentarily when a button is pushed.
9. A/B: This button toggles between Tuner A and Tuner B operation.
10. Disp: This button functions only for North American satellite radio use.
11. Numeric Buttons: These buttons (0-9) are used to access a specific station frequency or preset.
12. OK: This is a select button used for saving presets or entering an AM or FM frequency.
13. Band Buttons: These four buttons are a direct select for the tuning bands available through the T2 Tuners. Actual
functionality depends on the model Tuner being controlled.
PWR
1
TUNE
2
3
BAND
4
P
5
C
6
DISP
1
4
7
7
PRE
FM
DAB
T2 Tuner
NV-T2RC4
REMOTE CONTROL
A/B
TUNER
P
C
10
2 3
5 6
11
8 9
0 OK 12
AM
13
SAT
6
8
9