KVH Industries V7 User Manual page 31

12. If you wish to set up a second RF radiation hazard
zone, repeat steps 7-11. (Be sure the second zone does not
overlap the first.) Otherwise, press
display shows the current setting for Transmit
Inhibition ("XMT IN ZONES").
IMPORTANT!
Make sure "XMT IN ZONES" is set to NO, so the antenna
will not transmit whenever it points within one of your
configured RF radiation hazard zones. If "XMT IN ZONES"
is set to YES, the zones are disabled, allowing the antenna to
transmit within them.
XMT IN ZONES= NO
NEXT ITEM
13. If the display shows "XMT IN ZONES = NO," press
MENUS.
If the display shows "XMT IN ZONES = YES," press
CHANGE until the display shows "XMT IN ZONES = NO."
Then press ACCEPT.
XMT IN ZONES= NO?
CHANGE
14. Press EXIT to exit the menu.
TracPhone V7 User's Guide
Chapter 3 - Configuration
MENUS. The
CHANGE
ACCEPT
29