Table of Contents
Advertisement
5. In the Local Time Offset box, enter the offset in minutes from the GMT time in the
time zone in which the device operates (for instance, the offset for the Eastern
Standard Time is -300 minutes).
6. To continue the configuration process, select another parameter category in the
navigation pane. Otherwise, click Apply to save the changes in the device. Depending
on the changes you made, a reboot may be required; follow the on-screen instructions
in the Device Configuration Submittal pane.
Configuring HTTP (Webserver)
A series of parameters help configure the communication between the web page on the
computer and the device.
To configure the HTTP parameters:
1. In the navigation pane, expand Configuration > Advanced, then click HTTP
(Webserver). The HTTP parameters appear.
Note: If you change any of these parameters, you must refresh the web page (for
instance, by pressing F5).
2. In the HTTP Server IP Port box, enter the TCP port number in the device on which the
HTTP requests will be made. Default in all web applications is 80.
3. In the Web Streaming Method list, select the protocol used for transmitting video.
The available values are:
VSIP/UDP—A legacy protocol, using the proprietary VSIP video protocol over UDP.
The preferred UDP mode is RTP/UDP.
VSIP/TCP—A protocol using the proprietary VSIP video protocol over TCP. This
protocol guarantees proper reception of video packets, but could slow down the
effective frame rate to an unacceptable level (default).
Multicast UDP—A protocol using RTP (Real Time Transport Protocol, RFC 3550) over
UDP that transfers video to a multicast group. It does not guarantee proper
reception of video packets.
Verint Video Intelligence Solutions
Nextiva S2750e Series User Guide
37
Advertisement
Table of Contents
