Table of Contents
Advertisement
2: Mounting and Configuring the IP Camera
9. To activate the turbo mode of the automatic gain control, put the AGC DIP switch to the
ON position.
10. Put back the dome cover, taking into consideration the lens direction for the cover
opening.
11. Place the outer case back and secure the whole camera.
Configuring the Camera
The configuration steps to execute are:
Setting network parameters
Establishing a point-to-point connection between the camera and a receiver device, if
required
Device configuration requires the use of the proprietary SConfigurator tool. Its latest
version is included on the Verint web site (www.verint.com/manuals). You need to copy its
executable file (SConfigurator.exe) to the hard disk of your computer.
The minimum hardware and software requirements for the host computer needed to
configure the edge device are:
An Ethernet network card
Internet Explorer 6.0 or higher
Microsoft DirectX 8.1 or higher
Windows 2000 Service Pack 2 or higher, or Windows XP Service Pack 2 or higher
14
Verint Video Intelligence Solutions
Advertisement
Table of Contents
