Table of Contents
Advertisement
3: Using the Web Interface
Audio Hardware—The indication of whether audio hardware is present on the
device.
Unit Tested (MM-YY)—The date the device was tested by Verint production.
Board Temperature—The temperature of the main board (in degrees Celcius).
Configuring the Network
The network parameters allow communication between the device and its IP network. For
more information about these settings, contact your network administrator.
To configure the network parameters:
1. In the navigation pane, expand Configuration, then click Network. The network
parameters appear.
2. In the DHCP Configuration list, indicate whether DHCP (Dynamic Host Configuration
Protocol) is used to automatically provide a valid network configuration for the device.
You can set this option only if the device is connected to a network that uses a DHCP
server. For more information about DHCP, see Appendix B on page 52.
3. In the Local IP Address box, enter the unique IP address of the device on the
network. The IP address is written as four numbers separated by periods; each number
is in the 0–255 range. Each device on a network must have a unique IP address.
4. In the Subnet Mask box, enter the binary configuration that specifies the subnet in
which the IP address of the device belongs. A subnet is a portion of a network that
shares a common address component. Unless otherwise specified by your network
administrator, it is recommended to use a subnet mask of 255.255.0.0.
5. In the Gateway box, enter the IP address of the network point that acts as an entrance
to another network. Never use the IP address of the device as the gateway value.
6. In the Host Name box, enter an alias for the IP address of the device, to be used by
the DNS server; this parameter is optional. It is made up of 2 to 24 alphanumerical
characters; the first one must be a character.
Note: It is up to the DHCP server to register the host name in the DNS server.
28
Verint Video Intelligence Solutions
Advertisement
Table of Contents
