Chapter 2 Hardware Installation; Installation Overview - LSI MegaRAID SATA 150 User Manual

2.1

Installation Overview

Chapter 2
Hardware Installation
This chapter explains how to install the MegaRAID SATA150 storage
adapters. This chapter consists of the following sections:
•
Section 2.1, "Installation Overview"
•
Section 2.2, "Hardware Requirements"
•
Section 2.3, "Quick Installation Instructions"
•
Section 2.4, "Detailed Installation Instructions"
•
Section 2.5, "After Installing the Storage Adapter"
Here is a high-level overview of how to install, configure, and operate
MegaRAID SATA150 storage controllers.
Step 1. Install the Hardware. Refer to
Instructions,"
for hardware installation instructions.
Step 2. Configure the system BIOS. Refer to the system documentation
for more information.
Step 3. Run the MegaRAID setup utility to configure the Serial ATA
drives into a RAID array. Refer to the MegaRAID Software
User's Guide for more information.
Step 4. Install the operating system driver. Refer to the MegaRAID
Device Driver Installation User's Guide for more information.
Step 5. Install and run the MegaRAID Manager tool or the Power
Console Plus tool to manage the RAID system configuration
and performance. Refer to the MegaRAID Software User's
Guide for more information.
MegaRAID SATA150 PCI to Serial ATA Storage Adapters User's Guide
Copyright © 2002–2004 by LSI Logic Corporation. All rights reserved.
Section 2.3, "Quick Installation
or Section 2.4, "Detailed Installation Instructions,"
2-1