5.11.2 Installing The Transceiver; Figure 5-16. Installing Cables - Motorola ASTRO APX O2 User Manual

Motorcycle Radio Installation Transceiver and Cabling Installation
TRANSCEIVER
POWER CABLE
ACCESSORY
CABLE
CONTROL CABLE
(CAN)

5.11.2 Installing the Transceiver

Install the transceiver in the weather-resistant enclosure as follows (see
NOTE: For new or existing installations, use only the APX mobile trunnion (kit number: HLN7002_).
1. Install the mounting trunnion and loose ends of the four ground straps to the radio-mounting
plate, using four screws, flat washers, and external-tooth lock washers (see
ground straps must be sandwiched between the flat washers and lock washers. The lock
washer must be against the trunnion. The flat washer must be under the screw head.
2. Attach the transceiver to the mounting trunnion and secure with the two screws provided.
3. Connect the control cable to the front of the transceiver. Ensure the control-cable connector
screws are tightened.
4. Attach the accessory connector to the transceiver. Plug in the power connector.
5. Install the grommet around the cables and push the grommet into the cable-routing hole of
the weather-resistant enclosure.
6878215A01
ACCESSORY CABLE
ACCESSORY
EMERGENCY AND
CABLE HEADSET
EXTERNAL ALARM
CONNECTOR
CONNETOR
CONTROL HEAD CONTROL HEAD
POWER (RED) POWER FUSE

Figure 5-16. Installing Cables

HEADSET
SPORTING PLUG
EMERGENCY
CABLE SHORTING
PLUG
IGNITION SENSE
(ACC)
CONTROL HEAD
GROUND (BLACK)
Figure 5-17).
Figure 5-17). The
5-23