Table 2-1. Dash O2, O3, O5, O7 Or O9 Radio Operations Dependent Upon A+ And; Table 2-2. Remote O2, O3, O5, O7 Or O9 Radio Operations Dependent Upon A+ And; Table 2-3. Remote O2, O3, O5, O7 Or O9 Radio Operations Dependent Upon A+ And - Motorola ASTRO APX O2 User Manual

2-16
Table 2-1. Dash O2, O3, O5, O7 or O9 Radio Operations Dependent Upon A+ and Ignition Connections
Transceiver
Dash Mount Red Power
Wire
Connected to X
battery
Connected to
ignition switch
Ignition switch No ignition switch control.
controls
Table 2-2. Remote O2, O3, O5, O7 or O9 Radio Operations Dependent Upon A+ and Ignition Connections
Remote Control Head
Mount Red Wire
Connected to X
battery
Connected to
ignition switch
Ignition switch No ignition switch control.
controls
Table 2-3. Remote O2, O3, O5, O7 or O9 Radio Operations Dependent Upon A+ and Ignition Connections
Mid Power
Dash/Remote
Transceiver
Red Power
Wire
High Power
Dash/Remote
Connected to X
battery
Connected to
ignition switch
Ignition switch No ignition switch control.
controls
DO NOT connect any wires to the battery terminals until you have finished the entire
!
radio installation (Dash or Remote Mount) configuration to avoid potential equipment
damage.
C a u t i o n
Incorrect wiring of the radio may result in incorrect ignition sense detection, incorrect
power-on state, or incorrect power-off state of the radio system.
The Control Head Power cable wire (RED) and Transceiver Power cable wire (RED)
are always attached to the battery terminal and NOT to the ignition switch.
Transceiver
HLN6863
Red Power
Thin Red Wire
Wire
X X
Enables ignition switch functionality
as programmed in the codeplug.
Control Head Control Head
Yellow Wire Red Wire
X X
Enables ignition switch functionality
as programmed in the codeplug.
HLN6863
Thin Red Wire
Transceiver
at J2
Red Power
HLN6863
Wire
Thin Red Wire
at J626
X X
Enables ignition switch functionality
as programmed in the codeplug.
Standard Configurations Planning the Installation
Transceiver
HLN6863
Red Power
Thin Red Wire
Wire
X X
Illegal wiring configuration. See
CAUTION note.
Control Head Control Head
Yellow Wire Red Wire
X X
Illegal wiring configuration. See
CAUTION note.
HLN6863
Thin Red Wire
Transceiver
at J2
Red Power
HLN6863
Wire
Thin Red Wire
at J626
X X
Illegal wiring configuration. See
CAUTION note.
HLN6863
Thin Red Wire
X
X
Control Head
Yellow Wire
X
X
HLN6863
Thin Red Wire
at J2
HLN6863
Thin Red Wire
at J626
X
6878215A01