Standard Configurations Radio Mounting
2.2.2
Remote Mount with Trunnion
Before installing any electrical equipment, check the vehicle manufacturer's user
!
manual.
The installation of this device should be completed by an authorized servicer or
C a u t i o n
installer.
Before making any holes in the trunk for radio mounting, check the vehicle
manufacturer's user manual for restrictions (e.g. due to the gas tank location).
For a remote mount installation, the transceiver may be mounted anywhere in the vehicle, provided
that the installation location is safe, follows the cautions mentioned at the beginning of this section,
and is accessible for servicing/maintenance as well as cabling. A typical mounting location
recommended by Motorola is in the vehicle's trunk. The trunnion provided may still be used to mount
the transceiver, and the mounting process is the same as for the dash mount installation
(Section 2.2.1 on page
below in
Section
installation.
6878215A01
2-21). However, for 100W radios you must follow the procedure detailed
2.2.2.1. See
Figure
2-10,
Figure
2-11,
Figure
2-13, or
Figure 2-14
for a remote
2-23