Internal Speaker Disassembly; Figure 2-57. Removing The Screws On The Control Head; Figure 2-58. Removing The Control Head - Motorola ASTRO APX O2 User Manual

2-44
2.5.1

Internal Speaker Disassembly

NOTE: This configuration is only applicable for O2 Control Heads.
You can disable the internal speaker of your radio by following the instructions below.
Use the following procedure to disassemble your radio:
1. Unplug power, antenna, microphone and all accessories connections. If the radio is a
remote-mount radio, disconnect the remote-mount control cable from the front of the
transceiver.
2. Remove the four screws found on the control head with a Torx T-20 bit as shown in
Figure
3. Firmly grasp the front panel of the control head. Carefully remove the front housing assembly
from the back housing assembly as shown in
flex and do not pull on it excessively.
2-57. Discard the screws.

Figure 2-57. Removing the screws on the Control Head

Figure 2-58. Removing the Control Head

Standard Configurations Speaker
Figure 2-58. Note the position of the attached
6878215A01