Speaker, Microphone, And Universal Connector Flex Disassembly - Motorola GP200 Series Service Manual

Radio Disassembly — Detailed
Figure 3-7 Removing the Keypad Retainer and Other Boards from the Radio Body
6.4

Speaker, Microphone, and Universal Connector Flex Disassembly

Turn the screw at the bottom of the dustcover counterclockwise with your fingers. Lift the
1.
dustcover out of its pocket.
NOTE The dustcover must be removed to remove the speaker-microphone assembly flex circuit.
The speaker is held in place with a two-legged retainer bracket. The bracket legs are
secured by the front cover slots. Be careful not to damage the speaker when removing the
retainer bracket.
2. Using a screwdriver, push down on the portion of the speaker retainer bracket pointing toward
the bottom of the radio. Then, remove the retainer by slightly pushing it toward the top of the
radio until you slide it past the front cover slot.
3. Pull the rubber microphone boot from its seated position. Unless you are replacing the micro-
phone, leave it in the boot.
The speaker-microphone assembly flex circuit goes through the front cover wall to the out-
NOTE
side wall. To replace this assembly, you must peel-off the universal connector escutcheon
label. The existing escutcheon cannot be reassembled; a new part must be used. (See item
number 10 on the exploded view drawing.)
4. Peel-off the universal connector flex circuit escutcheon (label).
5. Pry the flex circuit (adhesive held) backer board away from the front cover, and remove the
universal connector tail of the speaker-microphone assembly through its opening in the front
cover.
Retainer
Display Module
Keypad Board Assembly
Keypad/Option Board
Keypad
Radio Body
3-9