Wired Door Controls - Merlin MT5580P Installation And Operating Instructions Manual

INSTALL WIRED DOOR CONTROLS (optional accessory)
27
Locate wired door controls where the garage door is visible, away from door and door hardware,
out of the reach of children and at a height of at least 1.5m.
Serious personal injury from a moving garage door may result from misuse of opener. Do not allow
children to operate the wired door controls or transmitters.
Fasten the caution label on the wall near wired door controls as a reminder of safe operating proce-
dures.
There are 2 screw terminals (1) on the back of the wired door controls (2). Strip about 6mm (1/4") of insula-
tion from bell wire (4). Separate wires enough to connect the white/red wire to terminal screw 1 and the
white wire to terminal screw 2.
Fasten wired door controls to an inside garage wall with sheet metal screws (3) provided. Drill 4mm (5/32")
holes and use anchors (6) if installing into plaster wall. A convenient place is beside the service door and
out of reach of children.
Run the bell wire up the wall and across the ceiling to the garage door opener. Use insulated staples (5) to
secure wire. Connect the bell wire to the spring terminals (located on the back panel) as follows: white/red
to 1 and white to 2
.
Push Bar Cover
4
24V
+
-
Com
No
24Vdc
GND
1
4
2
ANT
Press to open or close the door. Press again to reverse the door
during the closing cycle or to stop the door during opening cycle
3
24V
+
-
Com
No
24Vdc
GND
ANT
EXTERNAL RECEIVERS
Where a secondary receiver is required to
trigger your opener, power may be obtained
from the 24VDC output terminals located on the
back of your MT5580P.
1. Use the Grey 24VDC + (max 100mA) terminal and
the White GND Terminal supply power to your
24VDC receiver.
2. Run a bell wire from the COM and NO output of
your receiver into the Red and White terminals
located above the RED learn button.
OPERATION OF THE WIRED DOOR CONTROLS
16
6mm
5
3
6
.