Merlin MT5580P Installation And Operating Instructions Manual page 11

ATTACH MANUAL RELEASE ROPE & HANDLE
18
Thread one end of rope (1) through hole in top of red han-
dle so "NOTICE" reads right side up as shown (3). Secure
with an overhand knot (2). Knot should be at least 25mm
(1") from end of the rope to prevent slipping. Thread other
end of rope through hole in release arm of the outer trolley
(4). Adjust rope length so that handle is 1.8m (6 feet) above
the floor. Secure with an overhand knot.
Note: If it is necessary to cut rope, heat seal the cut end
to prevent fraying.
DO NOT DISENGAGE THE OPENER TO MANUAL OPERATION WITH CHILDREN, PERSONS OR OTHER OBJECTS
INCLUDING MOTOR VEHICLES WITHIN THE DOORWAY: (The door is under significant tension and if the door has
developed a fault or incorrect tension, it may be unsafe and may fall rapidly.)
Door should be released in the closed
position if possible.
To Disengage:
Pull down on the red handle.
DO NOT USE THE HANDLE TO OPEN OR
CLOSE THE DOOR.
To Engage:
Pull the red handle up and back towards the
opener. The trolley will engage when opener
is activated.
INSTALL THE LIGHT
19
Apply slight pressure on sides of the lens (2) and hinge the lens
cover down.
Install the 40 watt maximum light bulb (1) in the socket as shown.
The light will turn on and remain lit for 2-1/2 minutes when power is
connected. After 2-1/2 minutes it will turn off.
DOOR
2
DOOR
Disengaged
Max. 40W
E27
11
2
4
1
3
DOOR
Engaged
1
2
3