Security - Hughes 9202 User Manual

Security

General Telephony Settings:
Call Progress Tones: Two options are provided for call
progress tones. Option 1 is the default tones used in the USA.
Option 2 provides an alternative set of tones that are used in
Brazil and some European countries.
With Option 2 the ringing voltage changes to 36V rms on 48V
DC rather than just 48V rms AC.
Call Progress
Tone
Freq (Hz)
Dial 350 + 440 Steady ON
Ring Back 440 + 480 2 sec ON
Network 480 + 620 0.25 sec ON
Congestion
Busy 480 + 620 0.5 sec ON
You can configure three separate security settings on this page:
1) SIM PIN, 2) Phone to SIM PIN, and 3) Administration
Password.
SIM PIN – this is a four digit field that can be Enabled and
configured by the user to secure the terminal against unwanted
use. Once enabled, the terminal will require the SIM PIN at
startup.
Phone to SIM PIN – use up to 5 digits to lock the terminal to
the current SIM card. The Phone to SIM PIN code will have to
be entered any time the SIM card is changed. This setting is
similar to your GSM phone's security code. Default password is
12345.
Administration Password – this configuration allows the user
to prevent terminal settings from being changed once the
terminal is configured properly. This password will have to be
entered before any settings can be changed. See screenshots
below.
Option 1 (US)
Cadence
4 sec OFF
Repeating
0.25 sec OFF
Repeating
0.5 sec OFF
Repeating
3004149-0001 Revision C
Option 2 (Alternative)
Freq (Hz) Cadence
425 Steady On
425 1 sec ON
4 sec OFF
Repeating
425 0.5 sec ON
0.5 sec OFF
Repeating
425 0.25 sec On
0.25 sec OFF
Repeating

Using the Web UI
45