Converting The Oven Burner For L.p. Gas; Standing Pilot Models - Whirlpool SF3000SE W Service Manual

CONVERTING THE OVEN BURNER FOR L.P. GAS

1. Make sure that the oven control knob is in the
OFF position and pull the knob off the shaft.
2. Use a small screwdriver and turn the selector
to the L.P. position.
3. Install the knob on the control shaft.
4. Remove the oven racks.
5. Remove the two screws from the oven floor
and remove the floor.
screws

Standing Pilot Models

1-17
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
6. Remove the screws from the heat shield over
the oven burner and remove the shield.
heat shield
screws
1 " combination wrench and turn the
7. Use a /
2
orifice hood at the base of the oven burner
clockwise until it is just snug (approximately
1
2- / turns). NO NOT OVERTIGHTEN THE
2
HOOD.
hood
pin
Natural gas
increases
flame size in
this direction
4321890
Page 1-17
L.P. gas
increases flame
size in this direction