Whirlpool SF3000SE W Service Manual page 70

7. Remove the two flat-head screws from the
bottom of the hinge assembly, then, without
disturbing the arm, carefully lift the old hinge
assembly out of the oven door, and set it
aside.
UNHOOK THE
OVEN DOOR
LINER
HINGE
ASSEMBLY
INSULATION RETAINER
HINGE ASSEMBLY
LEFT SIDE TRIM
TAB FROM
THE SLOT
FLAT-HEAD
SCREWS
DOOR INSULATION
INNER DOOR
GLASS
OUTER DOOR
GLASS
8. Use the bottom of your shoe, and move the
arm on the defective hinge assembly from the
"broil position" to the "fully closed" position so
that it cannot snap closed accidentally and
cause an injury.
9. Install the new hinge assembly in the oven
door liner. Hook the tab at the top of the
assembly into the slot in the door liner, and
secure the bottom with two flat-head screws.
10. Using the bottom of your shoe, press down on
the hinge assembly arm that you just in-
stalled, and insert the pin into the hole in the
arm.
11. Reassemble the rest of the door and install it
on the range.
BOTTOM TRIM
3-30
DOOR LINER
HINGE ASSEMBLY
RIGHT SIDE TRIM