Electronic Ignition Models - Whirlpool SF3000SE W Service Manual

THE BAKE BURNER
NOTE: The oven burner is used for both bake and
broil functions. The burner can be controlled by a
knob, or by an electronic keypad. Refer to the oven
control on this, or the following page for the range
you are testing.
Control Knob
1. Push and turn the oven selector control knob
to 350˚F. The oven burner should light in 50-
to 60-seconds (the delay is due to the time it
takes for the gas valve to open and the gas to
flow to the burner).
2. Open the broiler door and check the flame
coming from the burner bar. If the flame is
noisy, or is blowing away from the bar, there
is too much air during combustion. If the flame
is soft and not high enough, there is not
enough air. If either of these conditions occur,
proceed to the next step.

Electronic Ignition Models

3. With the burner lit, loosen the locking screw,
and adjust the air shutter opening for the best
flame, then retighten the screw.
locking screw
air shutter
oven base
4. Turn the oven control knob to OFF.
1-20
oven burner
gas orifice