Atm/Pos - LG LRH7160D Series Owner's Manual

34 Installation
To register the IP device automatically
3
1. Click the [AUTO] button.
2. The search window will be displayed and start to search the IP
device automatically. By stopping or restarting the search, click
[Stop] or [Refresh] button.
3. Click the check box of desired device.
4. Enter the [User Name] and the [Password] and then click the
[Add] button. When you select several channels, channels are
assigned same ID and password.
5. Confirm the result of authentication on the [Verify] option.
• O: The verification is valid.
• X: The verification is invalid. Check the ID and password
again.
• XX: Connection failed.
6. Click the check box of confirmed cameras. Selected cameras are
registered channel in order.
7. Click the [CLOSE] button to exit the window.
To register the IP device manually
1. Click the [MANUAL] button.
2. Enter the IP address.
3. Click the check box of desired device.
4. Enter the [User Name] and the [Password] and then click the
[Add] button. When you select several channels, channels are
assigned same ID and password.
5. Confirm the result of authentication on the [Verify] option.
6. Click the check box of confirmed cameras. Selected cameras are
registered channel in order.
7. Click the [CLOSE] button to exit the window.
NOTE
• The Supported IP camera specifications.
Specification
Driver LGE, AXIS, ONVIF
Recording mode Continuous, Instant, Motion,
Sensor
Video Codec H.264, MPEG4, MJPEG
Audio recording and Support
playback
Resolution CIF, Half D1(2CIF), D1(4CIF), UXGA,
720p, 1080p (Up to 2048 x 1536)
Stream LGE (Master-0, Slave-0)
ONVIF (The stream that is
supported from camera)
AXIS (H.264, MPEG4, MJPEG)
PTZ Support
Sensor/Motion input Support
• It takes time to search IP devices and the necessary time
depends on the network environment.

ATM/POS

• Interface Device: Select the interface device from the drop-
down list.
- NONE: Selects when the ATM/POS device is connected with
the DVR directly.
- AVE Hydra: Selects when the ATM/POS device is connected
via the AVE Hydra device to the DVR. If you set to AVE Hydra,
the [Camera], [Baud Rate], [Data Bits], [Stop Bits] and [Parity]
options are dimmed and these options cannot be set.
• Camera: Select the camera number for mapping with ATM/POS
device.
• Baud Rate: Select the desired parameter to set the
communication speed between DVR and ATM/POS device.
• Data Bits: Select the number of the data bits for RS-485
communication.
• Stop Bits: Select the desired parameter. The stop bit is added to
the last of data, in asynchronous communication.
• Parity: Select the desired parameter. The parity bit is added to
the data, to perform parity check.
Description