Device Settings; Camera; Ptz - LG LRH7160D Series Owner's Manual

32 Installation

Device settings

Camera

3
• Ch: Displays the channel number.
• Name : Set the channel name by using alphabetic letter,
numeric digit and symbols up to 21 characters.
NOTE
If the [IP Enable] is set to [ON], you cannot set the [Device-
PTZ], [Record-Normal], [Record-Sensor], [Record-Motion],
[Record-Text], [Record-Instant/Panic] and [Event-Motion]
options because they are deactivated.
• Audio: Select the input audio channel. You can hear from the
selected input audio channel. If you set to ON for the IP channel,
you can hear the input audio of the IP camera.
• IP Enable :
On : Uses the camera as a IP camera.
Off : Uses the camera as a Analog camera.

PTZ

Settings for the PTZ cameras connected via the data port of the
RS-485 terminal.
• Channel: Selects the desired channel to set the connected PTZ
camera.
• Port: Selects the connected data port of the RS-485 terminal
on the rear panel. The DATA 2 port is used to control the PTZ
camera connected to DVR or to control by using the LKD1000
controller. If you want to use the PTZ camera via DATA 2 port,
you should set the [Remote Controller ID] to [NONE]. If you use
the LKD1000 controller to control the DVR via DATA 2 port, you
should set the [Remote Controller ID] number between 1 and
16. When you select [COAXIAL COMMUNICATION], [Protocol]
option is set to [PELCO_C] automatically and [Control ID], [Baud
Rate] options are deactivated.
• Control ID: Selects the PTZ camera ID. Make the same settings
as the PTZ camera.
• Protocol: Selects the protocol supported by PTZ camera.
• Baud Rate: Selects the communication speed.
• PTZ Test: After the PTZ setting, you can test the pan/tilt function
for the selected PTZ camera. You can see the test screen from
the preview windows on the right side of the PTZ test option.
- a/d: Tests the pan direction.
-
w/s: Tests the tilt direction.
NOTE
The supported PTZ camera list is on page 80 for reference.