Table of Contents
Advertisement
3.2.2 (not supported yet) Menu General Correction "Paper Feed Adjustment"
Use a torch or a light table to measure the job
length on both sides.
This is a basic adjustment to the system. Do the
length correction first before setting up the
PageSetups.
If an equal job length (paper feed direction) is not
printed equal on the front and back side printer, then
adjust this mismatch like:
First decide if you adjust the front or back side.
(1) Enter the current length from this side in the
field "Actual".
(2) In the field "Requested" enter the value you
need to match the other side.
Example
When comparing the front and the back side, the
back side job image is longer by 0,5 mm.
The distance between the crop marks in the paper
feed direction the back side is 640 mm. At the field
"Actual" enter the value 640 and on the field
"Requested" enter 639,5 mm.
3.2.3 Basic Paper Adjustment "Width"
If the paper roll width differs from one production lot
to the next lot more then 0.5mm in roll width, use
the value "Paper Lot Correction (Front)" (1) to
correct the width error .
Example
After changing the paper roll you recognize the new
roll is 1.0mm wider than the previous one.
Now, correct this error with a positive correction
value in 1/10 of Millimetre.
The correction value would be now 10.
Installation Manual – Configuration DJet Software
Software Configuration
DJet Setup
3
3-3
Advertisement
Table of Contents
