Table of Contents
Advertisement
3
Software Configuration
3.1
Set Input and Output Format
Open the menu Parameters -> Parameter
conversion
(1) Choose the input format which reflects the
prepress workflow rip's output. The input path is the
folder where the TIFF files are exported from the
Prepress Workflow Rip.
(3) Choose the output format "Epson DJet". Set the
output directory to point into the DI-Pilot input folder.
The output path is the input path for the DI-P i lot
Output Manager software.
Parameter name
(1)
Input format and input path
(2)
Flip/Negative
(3)
Output format and output path
(4)
Front/Back enable
(5)
Border Lines
(6)
Add Out
(7)
Resolution
Installation Manual – Configuration DJet Software
Function
Setup the input bitmap format and directory from your workflow.
Depending on the workflow setup you may have to set the check
boxes "Flip" (= mirroring) or "Negative.
The output format is "Epson DJet". Select an output directory
where the generated files are stored and further processed by
DI-P i lot.
Enable the double sided output for the DJet. Activate the
checkbox "Front/Back Enable".
Creates a thin border line around the job size limits
Select an additional output like CIP3, Inkzone or JDF data. After
the DJet data processing the selected output data is additionally
produced.
Bitmap calculation resolution. Note: this is not the printing
resolution. The printing resolution is set in the menu PageSetup.
Software Configuration
Set Input and Output Format
3
3-1
Advertisement
Table of Contents
