Epson D-Jet 300 Installation And Configuration Manual page 43

6.) Put the sheet on a light table or use a flashlight.
Measure the distance between the register
marks of the front and back side
(1) Register mark back side
(2) Register mark front side
(3) Y axis (paper feed direction)
(4) X axis (print head direction)
7.) The measured difference in this example would be:
Deviation X = 15 mm
Deviation Y = 9 mm
In the x direction, the crop mark from the back side
is too much on the right. To register the x axis, the
image on the back side has to move to the left (into
the sheet, away from the paper edge). Therefore the
correction value is positive, +15 mm.
In the y direction, the crop mark from the back side
is too high up. To register the y axis, the image on
the back side has to move down (move towards the
paper edge). Therefore the correction offset value is
negative, -9 mm.
Installation Manual – Configuration DJet Software
Register Front and Back side
Adjust Front and Back Side
+
6
+
6-5