Lpr On Sco Unix Hosts - Lantronix EPS1 Installation Manual

Eps installation guide for eps1 and eps2 ethernet print servers

Table of Contents

LPR Printing

The Add Remote Printer window will appear. SAM will prompt you for:

The printer name (the name of the print queue),

The remote system name (the EPS name),

The remote printer name (the EPS service),

The remote cancel model, and

The remote status model.

4.2.6 LPR on SCO UNIX Hosts

LPR is supported in SCO V3.2 release 4 with TCP/IP Version 1.2 and greater.

To configure a print queue using LPR, issue the mkdev rlp command. This will install the

Berkeley remote printing files and executable programs.

Note:

The mkdev rlp command should only be issued once, or serious prob-

lems will occur. If this happens, contact SCO technical support.

You can print to this queue using normal lp syntax once the remote printer is set up. To

create a remote printer:

Issue the rlpconf command.

4-10

TCP/IP Configuration

Table of Contents

Do you have a question about the EPS1 and is the answer not in the manual?

Eps2