Error Code Cause - Wascomat EXSM 230 S Operating & Maintenance Manual

72
Error codes
Given below is a brief summary of all the error codes and their causes. Starting on page 5 of
this section there are fault-finding charts for all error codes.
At the end of the chapter there are also charts for faults which do not generate error codes.

Error code Cause

01E Water level not reached within set time. Take necessary action. Press START again.
02E Door status switch open during program operation. Take necessary action. Press
START again.
The lock has not locked the door within the set time. Take necessary action. Press
03E
START again.
The temperature sensor indicates temperature below -5°C (open circuit).
04E
The temperature sensor indicates temperature above 98°C (short-circuit).
05E
The water level is above the safety level set for starting.
06E
The water level is above the safety level set for program operation.
07E
Temperature increase in water less than 5°C/10 min. (Heated machines).
08E
The water level is above the safety level set for after drain.
10E
The program control unit cannot read the program EPROM.
12E
Program control unit receiving no response from the motor control unit.
13E
Level system not temperature-calibrated. Press START to run the wash program.
14E
Program will run, but the water level will not be optimally adjusted.
17E Door status switch open, even though the door lock is locked.
43E Unbalance switch on when motor not rotating.
45E Tacho error
Trouble shooting