Function Control And Safety Checklist - Wascomat EXSM 230 S Operating & Maintenance Manual

Function control and safety checklist

22
Function control and
safety check list
In the machine cylinder, you will find the warranty
registration card, a copy of the warranty policy
and other pertinent material.
The warranty card should be completed and sent
to Wascomat. All other items should be placed in
a safe place for future reference.
The machine should be cleaned when the
installation is completed, and checked out as
detailed below without loading the machine with
fabrics:
• Make sure the machine is properly bolted to
Fig.
the floor..
21
• Make sure that all electrical and plumbing
Fig.
connections have been made in accordance
22
with applicable local codes.
1. Check the incoming power for proper voltage,
phase and cycles.
• Make sure the machine is properly grounded
electrically.
• Make sure that only flexible water fill and drain
hoses of the proper length to avoid sags and
kinks have been used.
2. Open the maunal water and steam valves.
3. Turn on electric power.
Before the machine is operated, the door safety
interlock must be checked for proper operation
as follows:
• When washer loading door is open, the
Fig.
machine must not start. Verify this by
23
attempting to start washer with door open.
• When washer is in operation, the loading door
Fig.
is locked and cannot be opened. Verify this by
24
attempting to open the loading door when the
machine is operating. If necessary, consult
this manual for proper operation of the door
lock and door safety interlock or call a
qualified serviceman.
Door safety interlock must be checked
daily in accordance with above procedure.
21
22
23
24
1762
4948
4944
4945