Dell C7008 Installing page 56

To configure the chassis from the BOOT_USER prompt, use the following commands:
Command
help
or
?
boot change {primary | secondary |
default}
show bootvar
show bootflash
interface management port config
100m
interface management port config
10m
interface management port config
auto-negotiate
interface management port config
no auto-negotiate
interface management port config
full-duplex
interface management port config
half-duplex
interface management port config
show
56 | System Boot
Purpose
• Enter help or ? to display a list of available commands and syntax.
• Enter syntax help t display syntax information and variable descriptions.
If your configuration displays no pre-configured operating system boot
parameters, use the boot change command to edit appropriate fields.
• The primary operating system boot parameters are used in the first attempt
to boot the system.
• The secondary operating system boot parameters are used if the primary
operating system boot selection is not available.
• The default operating system boot parameters are used if the secondary
operating system boot parameter is not available. The default parameters
always reside on the internal flash drive (flash).
NOTE:
These parameters, as well as other boot parameters, can be
modified in run-time mode
When you enter the boot change command, you are prompted for a response.
• Enter a new parameter or press the ENTER key (carriage return) to accept
the default parameter.
• Enter . (period) to clear a field.
• Enter - (dash) to edit a field above the current cursor position.
NOTE: When you enter a new parameter that extends beyond 80
characters, you cannot use the BACKSPACE key to correct any mistakes. If
you make a mistake, you must re-enter the parameter.
This command displays the current operating system boot configuration
parameters
This command displays information about the current boot ROM.
• Use these commands to set the speed and duplex settings for the
Management interface. The default setting is full-duplex and auto-
negotiation.
• Use the interface management port config show command to view
the management interface's physical settings.